Q: What is intermodulation? What causes intermods? A: Intermodulation generally only comes up in conversation when discussing interference. To understand about intermodulation products, or intermods, you need to know a little bit about transmitter and receiver design. Transmitters and receivers are designed to work at a particular frequency. High frequencies, such as those used in…

The Electromagnetic Spectrum is the range of all possible frequencies of electromagnetic radiation. See the excellent diagram reproduced by kind permission of Louis Keiner http://www.keiner.us/. The sections of particular interest to IPS members are usually referred to as the Radio Spectrum (although they are mostly used for television!), and are: Low Frequency (LF) covers frequencies…

Direct Current or DC refers to the unidirectional flow of electrons from high to low potential, as opposed to Alternating Current or AC where the flow regularly reverses in direction at a specific frequency. By convention this flow is considered to be from positive to relatively negative points; note that this direction is not the…

An Induction Loop or Audio Frequency Induction Loop System (AFILS) is a system commonly used by hearing aid users to clearly hear the sound in a theatre, through the bandit-proof glass screens in a bank or just a telephone call. It can also be used to provide wireless talkback or IEM to crew or presenters…

Tonader Power, T Power, T12 or AB Power all refer to a method of powering microphones via their cable. This system uses 180 ohm feed resistors and a 12V supply but does not send the DC power as a common mode signal like Phantom Power. The powering is unbalanced and shares the same path as…

Most mixers, except for portable types, have an associated Jackfield, also known as a Patchbay, either integral with the mixer frame or fitted nearby in a wall-mounted rack or free-standing console. The jackfield is used to terminate incoming lines from remote studios, tape machines etc and to provide access to the mixer line inputs and…

Earthing for Audio The following is taken from an article published in the Nov/Dec 2005 issue of LineUp by Peter Thomas, Managing Director of the Professional Monitor Company, with his kind permission. At the outset, I need to make clear that there are no references to PMC loudspeakers at all (except in this introduction). Neither…

The following hints and tips have been collated from emails on IBSNET. from Florian Camerer (ORF) I used the PD-2, which is – in my opinion – more reliably built (metal housing etc.) and consumes more power, yes, more power, and that means more heat in the machine!! I conducted tests in Vienna in a…

A member asked on IBSNET for advice on hydrophones. Chris Woolf responded:- Hydrophones vary quite a bit in quality from high grade phantom powered  devices to some pretty poor plug-in power versions. The are invariably omnis and since the propagation of sound in water is very different to air you can expect a lot of LF…

Advice/Tips on getting good sound for aircraft PTCs (Piece to Camera) The general advice here is to get your microphone as close as possible to the presenter’s mouth. A common technique is to attach your personal mic to the aviation boom but on the opposite side to the mouth as this helps shield the microphone…