AFL may be After-Fader Listen or After-Fader Level, depending on whether the user is more concerned with the quality and/or content of the signal or with its level. It is similar in operation to Pre-Fader Listen (PFL) except that the signal is derived after the channel fader instead of before. As AFL is also derived…

While it is possible to connect to Aircraft Intercom systems, the quality is at communications level rather than broadcast, though it may be adequate for short items and can give a useful “atmos”. Aside from the issues of obtaining the correct connector you MUST obtain permission from the pilot on each occasion before connecting location…

Advice/Tips on getting good sound for aircraft PTCs (Piece to Camera) The general advice here is to get your microphone as close as possible to the presenter’s mouth. A common technique is to attach your personal mic to the aviation boom but on the opposite side to the mouth as this helps shield the microphone…

Alternating Current or AC refers to a flow of electrons that reverses in direction in a cyclical manner

Amps (Amperes) measure the flow of current that a potential difference forces through a circuit. The symbol is always A. The name derives from the French physicist André-Marie Ampère (1775-1836). As with Volts, current can be unidirectional – Direct Current (DC) – or alternating in direction (AC), and the values used can be peak or…

Analogue audio signal levels have historically been categorised for professional usage in two groups – microphone level (low) and line level (high). Domestic equipment generally falls into a third category, just below professional line level. Signal levels are measured using units based on the Decibel. There are many different types of Level Meter used for…

This is a selection of computer software for audio applications which is either free or inexpensive. It has been compiled from various sources, and inclusion in this listing does not in any way imply any endorsement by the IPS, or any warranty that it will be satisfactory. User (and buyer) beware! Contents 1 PC Software…

Automated Dialog Replacement (ADR) was used by the Magnatech Corp as a marketing phrase (mid 1960s). Magnatech made the system which comprised the projector, the recorder and the control box. It enabled record drop-ins and -outs across 3 tracks (3 attempts) to be programmed to the footage counter, and the whole reel of 10 minutes…

Background Noise are sounds that are not the main sound you want to record. Sounds from traffic outside, air conditioning, lighting and so on. Ideally sources of background noise are stopped, switched off or removed but what do you do if you had no choice but record the noise? Record an atmos/room tone Wild Track…

Balanced lines are typically – and quite incorrectly – explained as follows. A signal is split into two equal but antiphase parts in a balanced line driver. These signals are connected to each leg of a pair cable and eventually arrive at a balanced receiver. This device inverts one leg of the signal. In doing…