(tag) – mics

A member asked on IBSNET for advice on hydrophones. Chris Woolf responded:- Hydrophones vary quite a bit in quality from high grade phantom powered  devices to some pretty poor plug-in power versions. The are invariably omnis and since the propagation of sound in water is very different to air you can expect a lot of LF…

Pressure Zone Microphone is a registered trade mark of Crown International, and describes a method of mounting a microphone close to a flat surface to minimise room acoustics. Other variants are described as Boundary Microphones. See http://www.uneeda-audio.com/pzm/

An Interference Tube is simply a long metal tube with a series of circumferential slots cut into it, fitted onto a directional Microphone. These slots produce interference patterns in sound waves from the sides, resulting in partial cancellation of off-axis sounds and a resultant apparent increase in the gain of sounds from directly in front.

Microphones work by sensing minute changes in air pressure. Pressure A pressure operated microphone is essentially a sensitive barometer and reacts only to changes in pressure irrespective of the direction of the sound source. It comprises a sealed box with air inside and a thin diaphragm that deflects for small pressure changes. Some form of…

The Polar Pattern of a Microphone describes its directional sensitivity. The main family of patterns is a continuous spectrum between omni and bi-directional (figure-of-eight). Thus their titles are somewhat arbitrary, often overlap and, perversely, in most cases they are best defined by their ability to reject sound. Polar Patterns are generalised – they give an…

Critical Distance or Dc is the distance from a sound source where the level of direct sound equals that of any reverberant sound. Dc applies to all sound gathering but measuring it is normally only required when advance planning of microphone positions is needed. Critical Distance does not dictate where a microphone must be placed…

Phantom Power is a means of powering condenser microphones remotely, using balanced microphone cable. The AES (and IEC 61938) endorses two voltage levels, 48 V and 12 V, and they are referred to as P48 and P12