(category) – Operational

Q: What is intermodulation? What causes intermods? A: Intermodulation generally only comes up in conversation when discussing interference. To understand about intermodulation products, or intermods, you need to know a little bit about transmitter and receiver design. Transmitters and receivers are designed to work at a particular frequency. High frequencies, such as those used in…

Tonader Power, T Power, T12 or AB Power all refer to a method of powering microphones via their cable. This system uses 180 ohm feed resistors and a 12V supply but does not send the DC power as a common mode signal like Phantom Power. The powering is unbalanced and shares the same path as…

The following hints and tips have been collated from emails on IBSNET. from Florian Camerer (ORF) I used the PD-2, which is – in my opinion – more reliably built (metal housing etc.) and consumes more power, yes, more power, and that means more heat in the machine!! I conducted tests in Vienna in a…

A member asked on IBSNET for advice on hydrophones. Chris Woolf responded:- Hydrophones vary quite a bit in quality from high grade phantom powered  devices to some pretty poor plug-in power versions. The are invariably omnis and since the propagation of sound in water is very different to air you can expect a lot of LF…

Advice/Tips on getting good sound for aircraft PTCs (Piece to Camera) The general advice here is to get your microphone as close as possible to the presenter’s mouth. A common technique is to attach your personal mic to the aviation boom but on the opposite side to the mouth as this helps shield the microphone…

“Off Tube” is when commentary for an event is provided by the commentary team just watching the televised pictures. While commentators almost always have a picture monitor (or “tube”) regardless of their location, there is great advantage to be had from also being in a position to see the proceedings with their own eyes, and…

A Cross Point is a notional intersection between an input and an output in a Matrix, which may be represented graphically by a cross-hatch of horizontal and vertical lines. Usually the horizontal lines represent the inputs and the vertical lines the outputs, and a cross overlaid at an intersection indicates a connection – a “cross…

Boom is defined in the Concise Oxford English Dictionary as “a movable arm carrying a microphone or film camera” and in Collins Concise as “a pole carrying an overhead microphone and projected over a film or television set“. In sound studios a boom is either an arm fixed to a floor-mounted microphone stand or a…

Foldback is a feed of audio to the studio, via either loudspeaker, headphone or earpiece (IEM). It may be to provide the presenter and/or performers with a Cue feed from an external source or from a singer’s Microphone, to reinforce a singer’s voice for confidence or as an aid to tuning, or to provide actors…

A “Cue” may be visual or aural. In television it is usual for somebody in the studio to be given a visual cue to begin by a wave from the Floor Manager, and also sometimes to conclude by “winding up” gestures (which become more frantic as time runs out!). In radio a cue light is…